Author
![]() |
JULRAT, SAKOL - Oak Ridge Institute For Science And Education (ORISE) |
![]() |
Trabelsi, Samir |
![]() |
STUART, NELSON - US Department Of Agriculture (USDA) |
|
Submitted to: IEEE Sensors Journal
Publication Type: Peer Reviewed Journal Publication Acceptance Date: 1/1/2018 Publication Date: 4/1/2018 Citation: Julrat, S., Trabelsi, S., Stuart, N.O. 2018. Open-ended half-mode substrate-integrated waveguide sensor for complex permittivity measurement. IEEE Sensors Journal. 18(7), 2759-2767. https://doi.org/10.1109/JSEN.2018.2801316. DOI: https://doi.org/10.1109/JSEN.2018.2801316 Interpretive Summary: Dielectric materials are generally considered poor conductors of electricity. The permittivity of a dielectric material is the physical characteristic of that material that determines its interaction with electric fields, and it can be described by a complex number, the real part of which is commonly known as the dielectric constant and the imaginary part is known as the dielectric loss factor. Materials with high dielectric loss factors will absorb energy rapidly from electric fields of sufficient strength and sufficiently high frequencies. Heating of foods in a microwave oven is an example of this conversion of electric energy to heat energy. Permittivities or dielectric properties of materials can be correlated with other physical properties of those materials such as moisture content, the amount of water in the materials. If the desired properties of materials are well correlated with their dielectric properties, those properties can be determined nondestructively by sensing or measuring the dielectric properties with suitable electronic instruments. Moisture testers for rapidly measuring the moisture content of agricultural crops such as grain and oilseeds are practical examples. New techniques are needed for sensing or measuring the dielectric properties of materials to improve or provide new quality-sensing equipment for practical applications in agriculture and related industries. This paper describes a new technique and type of device for sensing the microwave dielectric properties of materials, which might be developed for rapid sensing of quality factors in agricultural and other products. It involves microwave device waveguide components fabricated from double sided substrate material (sheet of dielectric material copper-clad on both sides) similar to PC cards. It uses an open-ended waveguide aperture to sense the dielectric properties of materials placed in contact with the open-ended waveguide aperture. Measurements were successfully completed that provided accurate determination of the dielectric properties of aqueous solutions of methanol, saline solutions, gelatin, and samples of canola seed, small spherical seeds. The results agreed very well with values obtained by conventional techniques for measuring the dielectric properties of these materials. Therefore, the novel technique offers promise for development of inexpensive sensors for practical use in sensing properties of agricultural products and other materials with portable instruments and in-line sensing devices. Technical Abstract: A novel open-ended half-mode substrate integrated waveguide (HMSIW) sensor with ground flange for dielectric permittivity measurement is presented in this paper. The open-ended HMSIW is designed and fabricated for C-band frequencies on FR4 substrate. The sensor model is described by using the aperture admittance model of open-ended waveguide. The permittivity of test material is determined by measuring the one-port reflection coefficient. Accurate measurement of permittivity was obtained by using the well-known three-materials calibration with air, distilled water and 25% ethanol aqueous solution. Predicted results for ethanol and 50% and 75% ethanol aqueous solutions are in good agreement with measurements by an open-ended coaxial-line probe. In addition, results of measurement on saline solutions, gelatin samples and canola seed are shown. |
