Page Banner

United States Department of Agriculture

Agricultural Research Service

Research Project: DEVELOP MANAGEMENT TOOLS FOR EARLY STRESS DETECTION AND EFFICIENT AGROCHEMICAL UTILIZATION FOR PROTECTED HORTICULTURE CROPS

Location: Application Technology Research Unit

Title: Predicting Calcite (CaCO3) Requirements of Sphagnum Peat Moss from pH Titration Curves

Authors
item Jeong, Ka Yeon - NORTH CAROLINA STATE UNIV
item Hesterberg, Dean - NORTH CAROLINA STATE UNIV
item Nelson, Paul - NORTH CAROLINA STATE UNIV
item Frantz, Jonathan

Submitted to: HortScience
Publication Type: Abstract Only
Publication Acceptance Date: April 15, 2009
Publication Date: July 1, 2009
Citation: Jeong, K., Hesterberg, D., Nelson, P., Frantz, J. 2009. Predicting Calcite (CaCO3) Requirements of Sphagnum Peat Moss from pH Titration Curves. HortScience. 44:1020.

Technical Abstract: Liming materials are required to neutralize acidity in peat moss to make it a suitable substrate for growing container crops. A series of time-consuming incubations of peat:lime mixtures are typically used to determine the liming rate to achieve a desired pH. Our objective was to evaluate the utility of a rapid, acid-base titration method for predicting calcite (CaCO3) requirement of sphagnum peat moss. In this method, peat moss with an initial pH of 3.7 was titrated in aqueous suspension with 0.1 M NaOH or 0.1 M HCl solution from pH 3 to 11 (forward titration), then from pH 11 to 3 (backward titration). Because of hysteresis, the forward and backward titration curves were averaged to predict calcite requirements. For comparison, peat moss samples were incubated in plastic bag for 13 days after applying calcite at rates between 0 and 1.5 mol CaCO3•kg-1 peat moss (dry weight basis), and pH was monitored until a steady-state was established. The pH achieved by incubation could be predicted up to pH 6.2 by the averaged acid-base titration curve. Above pH 6.2, calcite solubility limits caused a deviation between the two methods as the pH in the incubation experiment reached a plateau with increasing calcite additions. Geochemical speciation calculations showed that calcite solubility limits imposed by atmospheric CO2 and dissolved Ca2+ activity restricts the maximum pH achievable. Nevertheless, the acid-base titration is a quick method for accurately predicting calcite requirements of acidic peat moss for target pH levels below 6.2.

Last Modified: 8/29/2014
Footer Content Back to Top of Page