Page Banner

United States Department of Agriculture

Agricultural Research Service

Research Project: Construction of A Test Basin for Testing and Calibration of DSS-WISE

Location: Watershed Physical Processes Research Unit

Project Number: 6060-13000-023-22
Project Type: Reimbursable

Start Date: Apr 04, 2011
End Date: Aug 15, 2012

Objective:
Perform hydraulic experiments specifically designed to validate the performance of numerical models used to predict the movement of a flood wave resulting from a dam break.

Approach:
Numerical models are an important tool used in many areas of engineering and science that allow for rapid, inexpensive simulation of a variety of conditions. Accurate numerical modeling requires calibration by laboratory or field data. This helps to ensure that the model adequately captures the physics of the physical system and gives a standard to use in model testing and development. The need for calibration is especially relevant for hydraulic models, where bulk flow and turbulent quantities interact with structures such as streambeds, stream banks, dams, etc., in very complex ways. A new hydraulic model testing facility is to be constructed and housed at the National Sedimentation Laboratory. The facility will be designed and built for measuring transient flow during dam break scenarios. The design will also allow for convenient reconfiguration to meet future needs for model calibration and validation. High speed cameras and acoustic sensors will be used to record water surface profile data that will be compared to model results. The three general configurations which the facility will be designed for are as follows: 1. Simple dam break—non channelized flow. The downstream area will be wide with respect to the breach and can be equipped with or without sidewalls. Both dry and wet downstream conditions will be possible. Allowances will be made to add obstacles to the flow such as positive cutlines that are high or overtoppable and negative cutlines (dips, cuts). 2. Simple dam break—channelized flow. Configurable with/without bends with a free overfall at the end of test section. Wet or dry downstream with obstacles such as positive cutlines that are high or overtoppable and negative cutlines. 3. 1D-2D coupling with channel in line with dam breach and with/without irregular sidewall heights.

Last Modified: 11/24/2014
Footer Content Back to Top of Page