New Pressure Tester Helps Fine-Tune Irrigation Systems
Just a quick squeeze of the flexible black tubing in their drip-irrigation
systems is all some growers need to estimate water pressure. To reach
every thirsty plant, water needs to flow through these hoses, called
drip tape, at the correct pressure. In fields and orchards with uneven
terrain, correct water pressure is especially critical.
Now, ARS agricultural engineers
Dennis C. Kincaid and Thomas J. Trout have invented a portable device
that makes it more convenient for growers to spot-check water pressure.
The scientists have nicknamed the instrument "the squeezer."
Kincaid is based at the ARS Northwest Irrigation and Soils Research
Laboratory, in Kimberly, Idaho. Trout is with the ARS Water Management
Research Laboratory, in Parlier, California.
The unit weighs close to a pound, is about the size of a pipe wrench,
and is accurate to within the accepted 5 percent. Kincaid and Trout
have made prototypes of steel and of aluminum, and they estimate that
the squeezer could be manufactured at a reasonable cost.
The squeezer is suitable for drip systemsalso called microirrigation
systemsthat use thin-walled, easily compressed tubing that's either
above ground or buried. Drip systems irrigate an estimated 3 million
acres of farmland in the United States.
The new tester isn't intended to replace today's permanently installed
meters and gauges, but instead is a handy option for special situations.
For example, it can be used with temporary drip systems that are pulled
up after harvest.
"Growers can easily use the squeezer to verify pressure at different
points along the drip lines," Kincaid notes. Too, consultants or
Cooperative Extension irrigation specialists "can carry the tester
to inspect permanently installed drip systems," says Trout. "That's
a practical way to determine whether a system is working properly or
The squeezer works somewhat like a clothespin. Says Kincaid, "First
you grip the handles, then adjust them until the two small metal platesthe
jawsfit around the drip tape. Then, you tighten the small wing
nut to compress the spring until the alignment indicator shows that
you have correctly positioned the squeezer.
"The pointer and scale connected to the spring indicate the water
pressure in pounds per square inch. Our electronic version of the squeezer
works on the same principle but uses an electronic force sensor, or
load cell, and digital readout."
For buried drip systems, growers can dig small holes to access tubing,
or measure pressure at points where tape emerges from the ground.
Kincaid and Trout used standard 16-millimeter-diameter drip tape to
calibrate the squeezer, but they note that it can be used with other
sizes of tape, as well.By Marcia
Wood, Agricultural Research Service Information Staff.
This research is part of Water Quality and Management, an ARS National
Program (#201) described on the World Wide Web at www.nps.ars.usda.gov.
For further information on U.S. Patent Application No. 10/060,467,
"Fluid Pressure Measurement by Mechanical Compression of Tubing,"
contact Dennis C. Kincaid,
USDA-ARS Northwest Irrigation
and Soils Research Laboratory, 3793 N., 3600 E., Kimberly, ID 83341;
phone (208) 423-6503, fax (208) 423-6555.
"New Pressure Tester Helps Fine-Tune Irrigation Systems" was published in the July 2003 issue of Agricultural Research magazine.